Assembly Instructions

A 6 ea

Bottom vertical tube

B 6 ea

Top vertical tube

F 4 ea

Threaded shelf stud

H 42 ea

Hex screw

I 1 ea

Hex wrench

G 5 ea

Shelf

C 4 ea

Long horizontal tube

D 9 ea

Short horizontal tube

E 2 ea

Horizontal hanging tube

Assembly

Time:

Less than

60 minutes.

This product's intended

use is for hanging

garments and storage.

Tools Needed:

No extra tools required.

STEP 2. Bottom section: Insert the studs of one shelf (G) with

threaded studs (F) from step 1 into two bottom vertical tubes (A).

Thread two long horizontal tubes (C) onto shelf studs and tighten

the tubes by hand. Assemble the remaining four bottom vertical

tubes (A), three short horizontal tubes (D) and one shelf (G) using

hex screws (H). Tighten with hex wrench (I).

STEP 1. Start by inserting two threaded shelf studs (F)

into the end of a shelf (G). Twist until tight. Repeat for a

second shelf.

STEP 3. Top section: Insert two top vertical tubes (B) into the

middle bottom vertical tubes (A) aligning the holes. Insert the

remaining shelf (G) with threaded studs (F) from step 1 into the top

holes in the two middle top vertical tubes (B). Thread two long

horizontal tubes (C) onto shelf studs and tighten the tubes by hand.

Assemble the remaining four top vertical tubes (B), short horizontal

tubes (D), and two horizontal hanging tubes (E) using hex screws

(H). Tighten all hex screws with hex wrench (I).

PAGE 1
6905-8385 Gunmetal Double Rod Closet ©2017 Whitmor, Inc. A 6 ea Bottom vertical tube H 42 ea F 4 ea B 6 ea Assembly Time: Less than 60 minutes. Hex screw Threaded shelf stud Top vertical tube I 1 ea Hex wrench C 4 ea This product's intended use is for hanging garments and storage. Long horizontal tube D 9 ea E 2 ea Short horizontal tube G 5 ea Horizontal hanging tube Shelf STEP 1. Start by inserting two threaded shelf studs (F) into the end of a shelf (G). Twist until tight.
PAGE 2
6905-8385 Gunmetal Double Rod Closet STEP 4. Insert the two remaining shelves (G) aligning with the holes in the vertical tubes. Attach with eight hex screws (H) and tighten with hex wrench (I). ©2017 Whitmor, Inc. STEP 5. Assembly is now complete.