3SWH0408195. Shelf

ManualsBrandsWholesale Interiors ManualsHome Furnishing3SWH0408195-WHITE-SHELF Elton Modern and Contemporary White Finished Metal 3-Shelf Free-Standing Closet Storage Organizer

Read these precautions before assembly to ensure your safety and to prevent damage to the product.

●

Wear gloves during assembly or disassembly.

●

Do not press against protrusions or edges as doing so may cause injury.

●

Do not apply excessive force to the product.

●

Do not climb or hang on the product.

●

Do not exceed the maximum load capacity of 50 kg/110 lbs per shelf. Ensure that objects on shelves are evenly distributed to maintain balance.

●

Use a soft, dry cloth to clean regularly. Wipe spills immediately and completely with a dry towel.

●

Keep the product in a dry and well-ventilated place. Exposure to humidity over a long period may cause shelf boards to bend or twist.

●

Do not keep the product in a high temperature environment or near heat sources or chemicals.

●

The warranty does not cover damage caused by misuse or negligence.

■

Required tools

The product cannot be installed without the assembly hammer provided.

■

Securing the rack to the wall

Secure the rack to the wall. If the rack is not properly secured to the wall, it may fall

forward, causing property damage or injury.

■

Post assembly

When setting up posts, make sure that the small squares of the post holes face

downward.

When connecting post connection brackets to the posts, hammer both sides of the

top of the post. Hitting only one side may cause the posts to bend or twist.

■

Support beam assembly

Support beams have 2 tabs on each side. Make sure each tab is hooked securely into

the smaller squares of the post holes. Failure to do so may cause the beams to shake

or tilt.

When connecting the opposite end of a support beam, tightly hold its center with

one hand to prevent it from bouncing.

SAFETY PRECAUTIONS

INSTALLATION PRECAUTIONS

COMPONENTS

Assembly Hammer

Shelf

Post Connecting

Bracket

Support

Beam

Safety Cap

Wall Bracket

Screw

Hanger Bar

Hanger

Support Beam

(Left/Right)

Rack Connector

(for 2 or more racks)

■

Connection between post and support beam

The top of the circle on the support beam must line up with the post as shown.

Incorrect Correct

Support beams can be installed in

either direction, upward or downward,

to create shelves or trays.

Tip

Shelf

Basket

Summary of content (2 pages)

PAGE 1
SAFETY PRECAUTIONS Read these precautions before assembly to ensure your safety and to prevent damage to the product. ●● Wear gloves during assembly or disassembly. ●● Do not press against protrusions or edges as doing so may cause injury. ●● Do not apply excessive force to the product. ●● Do not climb or hang on the product. ●● Do not exceed the maximum load capacity of 50 kg/110 lbs per shelf. Ensure that objects on shelves are evenly distributed to maintain balance.
PAGE 2
ASSEMBLING GUIDE Post X 4 Post X 8 Shelf X 3 1 2 Support Beam X 4 Support Beam X 6 Post Connecting Bracket X 8 Hanger Bar Hanger Support Beam (Left/Right) Safety Cap X 16 Wall Bracket X 2 Screw X 2 Rack Connector X 2 Assembly Hammer 3 4 5 4X When setting up posts, make sure that the small squares of the post holes face downward.