Assembly Instructions

ManualsBrandsWholesale Interiors ManualsBedsQueen Size Bed Light Blue

NO PART LIST

QTY

BACK REST

1PC

SIDE PANEL

(L)

FRONT

SIDE RAIL

LEG

ITEM

HARDWARE

QTY

JCBB SCREW

M8 x 20MM

L - KEY

M5 x 65MM

1PC

4PCS

2PCS

14PCS

STEP 1

STEP 2

ABBIE DAYBED-F / ABBIE DAYBED-Q

SIDE PANEL

(R)

Please do not tighten the hardware until the entire assembly is completed.

SLAT

2 SET

SPRING WASHER

FLAT WASHER

L - KEY

M4 x 65MM

SCREW

M4 x 32MM

12PCS

1PC

7pcs

SLAT

SUPPORT

LEG

BACK

SIDE RAIL

1PC

JCBC SCREW

M6 x 50MM

8PCS

4PCS

Begin assembly by attaching each Leg (6) to the

bottom of the Side Panel (2) & (3) securing with

2 Allen Bolt (B) per panel using L-key (F).

Then attach the Back Side Rail (5) to the Side Panel

(2) & (3) by aligning holes and securing with 2

Allen Bolts (A) per each side using L-key (G).

And attach the Front Side Rail (4) also by aligning

holes and securing with 4 Allen Bolts (A) per

side using L-key (G).

(DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)

Attach the Back Rest (1) to the back of each Side Panel (2) & (3) by aligning

the hole and securing with 2 Allen Bolts (B), 2 Spring Washer (C),

2 Flat Washer (D) from the back side per each end

using L-key (F).

(DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)

STEP 1.2

STEP 1.1

Summary of content (2 pages)

PAGE 1
ABBIE DAYBED-F / ABBIE DAYBED-Q NO QTY PART LIST 1 BACK REST 1PC 2 SIDE PANEL (L) 1PC 3 SIDE PANEL (R) 1PC 4 FRONT SIDE RAIL 1PC 5 BACK SIDE RAIL 1PC 6 LEG 4PCS SLAT 2 SET 7 7pcs 8 SLAT SUPPORT 1PC 9 SUPPORT LEG 2PCS ITEM HARDWARE QTY A JCBB SCREW M8 x 20MM 12PCS B JCBC SCREW M6 x 50MM 8PCS C SPRING WASHER 4PCS FLAT WASHER 4PCS D E SCREW M4 x 32MM 14PCS F L - KEY M4 x 65MM 1PC G L - KEY M5 x 65MM 1PC STEP 1 Begin assembly by attaching each Leg (6) to th
PAGE 2
STEP 3 Secure 2 Support Leg (9) to the Slat Support (8) as shown on step 3.1. Insert the pre-set metal on Slat Support (8) to the metal bracket on each side of Side Panel (2) & (3). Then securing the metal bracket as shown in step 3.3 with 1 Screw (E) each side using Phillips Head Screwdriver (NOT INCLUDED) STEP 3.1 8 8 STEP 4 Tighten All Bolts from step 1 to step 3 by using L-key (F) & (G) that has been provided.