Assembly Guide

Table Of Contents

ASSEMBLY INSTRUCTION

MODEL : 339C

Read this instruction carefully. Remove all wrapping material, staples and straps from the

carton. See hardware and furniture part list

For guidance. Be sure you have all wooden furniture parts on a clean and flat soft surface,

such as a carpet or rug, to prevent from being scratched.Follow the figure to start assembling.

CAUTION :

1. Do not FULLY - TIGHTEN the nut or screw untill all is ready to assemble.

2. Do not OVER - TIGHTEN the nut or screw to avoid causing damages to the thread.

3. Keep all hardware part out reach of children.

PART LISTNO QTY

BACK REST

FRONT LEG

SIDE RAIL 2 PCS

WOODEN SEAT WITH SCOOP 1 PC

1 PC

DESRIPTIONNO

QTY

JCBC SCREW M6 X 50MM

WOOD DOWEL Ø8 x 30MM

CSK SCREW M4 x 30MM

SPRNG WASHER M6

M4 ALLEN KEY

6 PCS

4 PCS

3 PCS

6 PCS

1 PC

COMPELETE ASSEMBLE

STEP 1

Attached C to B according to

the hole and tighten it using

hardware number 1,2,4, and 5 .

STEP 2

Align the whole part from STEP1

to A . Tighten the part of C and

A using hardware number 1,4

and 5 .

STEP 3

Stick D to the whole assemble

part and fully-tighten it with

hardware number 3 .

STEP 4

3 X 3PCS

PAGE 1
ASSEMBLY INSTRUCTION MODEL : 339C Read this instruction carefully. Remove all wrapping material, staples and straps from the carton. See hardware and furniture part list For guidance. Be sure you have all wooden furniture parts on a clean and flat soft surface, such as a carpet or rug, to prevent from being scratched.Follow the figure to start assembling. CAUTION : 1. Do not FULLY - TIGHTEN the nut or screw untill all is ready to assemble. 2.
PAGE 2
ASSEMBLY INSTRUCTIONS MODEL : 7048T Read this instruction carefully, remove all wrapping material, staples and straps from the carton. See hardware and furniture part list. For guidance. Be sure you have all wooden furniture parts on a clean and soft surface to prevent from being scratched. Follow the figure to start assembling. Caution: 1. Do not FULLY –TIGHTEN the nut or bolt until all nut or nut bolt is ready to assembled. 2.