Installation Guide

6.
Optionally,securetheSafetySwitchbrackettothewall/pole,using1-3screws:
NOTE
In case of inverter replacement with the Safety Switch still mounted, it is recommended to use all
3 holes.
a.
MarkthelocationofthebracketscrewfortheSafetySwitch,andoptionallythetwo
additionalbracketholes.

Figure 18: Safety Switch bracket
b. Removetheinverterfromthewall/pole.
c. DrilltheholefortheSafetySwitchbracket.
d. Hangtheinverteronthemountedbrackets.
e. FastentheSafetySwitchbracketusingastandardbolt.
7. Insertthescrewsatthetopoftheinverterbracketsandfastenthebracketstogether.
8. Verifythatallthebracketsarefirmlyattachedtothemountingsurface.
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
28
Mounting the Inverter