Installation Manual

ManualsBrandsWholesale Solar ManualsSystemKing Of The Road RV Kit

Safety and Installation Instructions

This document applies to all SunPower modules

listed in Table 1.

Contents of this manual are subject to change without notice.

For the latest manual please refer to www.sunpower.com/PVInstallGuideFlexModules

SunPower Corporation

www.sunpower.com

Document 524958 REV E

Summary of content (4 pages)

PAGE 1
Safety and Installation Instructions This document applies to all SunPower modules listed in Table 1. Contents of this manual are subject to change without notice. For the latest manual please refer to www.sunpower.com/PVInstallGuideFlexModules SunPower Corporation www.sunpower.
PAGE 2
Safety and Installation Instructions 1.0 Introduction This manual provides safety and installation instructions for SunPower flexible photovoltaic (PV) modules. IMPORTANT! Please read this manual in its entirety before installing, wiring, or using this product in any way. Failure to comply with these instructions will invalidate the SunPower Limited Warranty for PV Modules. 1.1 Disclaimer of Liability The installation techniques, handling, and use of this product are beyond company control.
PAGE 3
Table 1: Electrical Characteristics1 Typical Electrical Data at STC: 25° C, 1000 W/m2 and AM 1.5 Model SPR-E-Flex-50 SPR-E-Flex-100 SPR-E-Flex-110 SPR-E-Flex-170 (4x12) SPR-E-Flex-170 (6x8) 170 W Nominal Power (Pnom) 50 W 100 W 110 W 170 W Power Tolerance +/-5% +6/–3% +6/–3% +/-3% +/-3% Rated Voltage (Vmpp) 17.7 V 17.1 V 18.8 V 29.9 V 29.4 V Rated Current (Impp) 2.8 A 5.9 A 5.9 A 5.79 A 5.84 A Open circuit voltage (Voc) 21.5 V 21.4 V 22.8 V 34.8 V 34.
PAGE 4
DANGER! • SunPower does not recommend connecting these panels in parallel without proper system and safety protection. • Connecting panels in parallel will double the current output of the panels. DC Currents may be greater than 12 amps for 100 W, 110 W and 170 W, and greater than 6amps for 50 W, in high illumination conditions (>1000 W/m2).