SNO 3 IN 1 ICE MAKER, CRUSHER & WATER DISPENSER MODEL: ICE-100S
Introduction Unpacking your unit Thank you for purchasing this SNO 3 IN 1 ICE MAKER, CRUSHER AND WATER DISPENSER by Whynter. To ensure that you enjoy years of trouble-free operation, please read and follow the instructions contained in this manual. Please retain these instructions for future reference. IMPORTANT – this unit is heavy (53lbs) – to prevent injury, please seek assistance when removing from packaging. Features - Makes ice cubes, crushed ice and cold water.
Controls 10 Manual water fill compartment Please refer to the diagrams below and familiarise yourself with the operating buttons.
Installation Instructions 1) As with all refrigeration equipment, this appliance should be settled for at least five hours prior to switching on the appliance. 2) The power supply must be an earthed 110V AC 60Hz mains supply. 1) Choose your required water supply method: a. Water line supply - Use the provided water hose (17) to connect to your household water supply (Fig. 1). If assistance is required, please contact a certified plumber. Connect the water hose connector to a water faucet.
2) Using the ON/OFF switch (1) at the side of the unit, switch the power ON. The POWER light (8) on the top of the unit will illuminate red. 3) Press the START button (2) at the top of the unit. The water level will be automatically checked and, if correctly filled, the red light will turn green. If the water level is still incorrect after 50 seconds, the LOW WATER light (9) will flash in orange and the POWER light (8) will flash in red.
Maintenance 1) Do not use any commercial chemical cleaning agent, acidic agent, naphtha decontamination powders, etc to clean the machine. Our recommended cleaning agent is vinegar and water solution. 2) Cleaning agent must be added through the manual fill compartment (10) only. 3) Do not allow water to be in the reservoir for more than a few days. The water reservoir should be drained and the SELF CLEAN function should be used.
facing front and center. 2. Unit needs to be restarted. 2. Turn off the unit for a minute and turn back on then push Start button. 3. Insufficient water pressure. 3. Take off the bottle and manual fill the unit with water. 4. Bottle has a cap or seal. 4. Remove cap or seal then reposition bottle back on to bottle supporter. Turn on Power and push Start button. Water pressure is too high or low. Reduce or increase the water pressure.
ONE YEAR LIMITED WARRANTY This WHYNTER SNO 3 in 1 ice maker is warranted, to the original owner within the 48 continental states, for one year from the date of purchase against defects in material and workmanship under normal use and service.
