User Manual

Installation

REMOVE PACKAGING MATERIALS

IMPORTANT: Do not remove any permanent instruction labels or the data label on your convertible refrigerator/

deep freezer

REMOVE TAPE AND CLUE FROM YOUR UPRIGHT FREEZER BEFORE USING

 To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be

easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with

warm water and dry.

 Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.

These products can damage the surface of your convertible refrigerator/deep freezer.

CLEANING BEFORE USE

 After you remove all of the packaging materials, clean the inside of your convertible refrigerator/deep freezer

before using it.

INSTALLATION CLEARANCES

Your convertible refrigerator/deep freezer should be conveniently located for day-to-day use in a dry, well-

ventilated room. Do not install the convertible refrigerator/deep freezer where the temperature will go below 50°F

or above 90°F, because it will not maintain proper temperatures. Be sure to install your convertible refrigerator/

deep freezer on a floor strong enough to support it when it is fully loaded.

FREESTANDING INSTALLATION

A freestanding installation will allow you to install the convertible refrigerator/deep freezer in any place you desire

provided that the required clearance space around the appliance is respected. In every setting, there must be

adequate ventilation and access for service. Never install or operate the unit in an enclosed area, such as a

closed cabinet.

 Before connecting the convertible refrigerator/deep freezer to the power source, let it stand upright for ap-

proximately 4 hours. This will reduce the possibility of a malfunction in the cooling system from handling dur-

ing transportation.

 The normal operation of the convertible refrigerator/deep freezer depends on heat radiation from the conden-

ser. Allow at least 6 inches of space between the back and sides of the appliance, which allows the proper air

circulation to cool the compressor and condenser. The installation should allow the convertible refrigerator/

deep freezer to be pulled forward for servicing if necessary.

 This unit MUST be installed in an area protected from the elements, e.g., wind, rain, water spray or drips. Do

NOT use the convertible refrigerator/deep freezer in outdoor setting.

 The convertible refrigerator/deep freezer should not be located next to ovens, grills or other high heat re-

sources.

 Too much humidity in the air will cause frost to form quickly on the evaporator requiring more frequent de-

frosting of the convertible refrigerator/deep freezer.

 Avoid locating the appliance in area that may be exposed to excessive moisture.

 The convertible refrigerator/deep freezer must be installed with all electrical requirements followed.

 The unit should be located on a hard and level surface that can support the unit when it is full. It is important

for the convertible refrigerator/deep freezer to be level in order to work properly. If needed, you can adjust the

height of the convertible refrigerator/deep freezer by turning the feet. See the “Leveling the Upright Freezer”

section.

Excessive Weight Hazard

Two or more people should move and install convertible refrigerator/deep freezer. Failure to do so can result in

back or other injury.