Quick User Guide User Manual

Powering & Pairing
1. First turn ON the transmitter (Tx) and the
receiver (Rx) units by pressing and
holding the POWER button , on each
of the units for 2 seconds.
2. Press and hold the LINK button on the
transmitter (Tx) for 3 seconds. The Power/
Status LED on the transmitter will start
fl ashing. The transmitter is now in a Pairing
mode and ready to search for receivers.
3. Press and hold the LINK button on the
receiver (Rx) for 3 seconds. The Power/
Status LED on the receiver will start fl ashing.
The receiver is now in a Pairing mode and
ready to be found by the transmitter.
4. Once the transmitter pairs with the receiver
the Power/Status LED on both devices will
turn to solid Green.








(Tx)(Rx)
