User Guide Instruction Manual

Pairing the Wi AudioStream!
Before using the Wi AudioStream with your instruments, you need to pair the transmitter with the receiver.
Pairing will create a connection between the transmitter and the receiver.
1. First turn ON the transmitter (Tx) and the receiver (Rx) by pressing and
holding the POWER button , on each of the units for 2 seconds.
2. Press and hold the LINK button on the transmitter (Tx) for 3 seconds.
The Power/Status LED on the transmitter will start ashing. The transmitter
is now in a Pairing mode and ready to search for receivers.
3. Press and hold the LINK button on the receiver (Rx) for 3 seconds.
The Power/Status LED on the receiver will start ashing. The receiver
is now in a Pairing mode and ready to be found by the transmitter.
4. Once the transmitter pairs with receiver, the Power/Status LED on both
devices will turn to solid Green.
5. The Wi AudioStream transmitter and receiver are now ready for use.
PARING
Wi AudioStream
19
p
k
(Tx)
p
k
z
v
z
v
(Rx)