User Guide Instruction Manual

5.1 For Stereo MIC Connection
a. Power up the transmitter by pressing and holding the POWER button for 2 seconds.
b. Press and hold the Mode button for 2 seconds. The Blue LED will display slow ashes
F The slow ashing blue LED indicates stereo MIC connection mode and the ashing Green LED
indicates the transmitter is searching for the receiver. The ashing Green LED on the transmitter
will turn to solid green once the receiver is powered up, paired and linked with the transmitter.
F The standard factory power up setting is set for stereo Line-in with two ashing Blue LED ashes.
The transmitter can remember the last power up mode selected .To change the startup mode to the
desired operation mode please refer to the “Tx Function Matrix” of this manual for detailed instructions.
5.2 For Mono MIC Connection
a. Power up the transmitter by pressing and holding the POWER button for 2 seconds.
b. Press and hold the Mode button until the Blue LED displays fast ashes
F The fast ashing Blue LED indicates Mono MIC connection mode and the ashing Green LED
indicates the transmitter is searching for the receiver . The ashing Green LED on the transmitter
will turn to solid green once the receiver is powered up, paired and inked with the transmitter.
6. Attach the Wi AudioStream transmitter to your belt.
F Please proceed to page 22 for receiver connection instructions.
TRANSMITTER CONNECTION
Wi AudioStream
21
r
k
(Tx)
k
r
k
r