User guide

Troubleshooting
If you have problems using the iMuffs Stereo Bluetooth
Headphones, this section may help. For further assitance,
please visit www.wi-gear.com.
Most problems can be resolved with a simple reset.
Switch the headphones off, and then on. Unplug the
adapter from the iPod, plug it back in.
You hear no sound.
Ensure the headphones are switched on and the adapter
for iPod is plugged into a compatible iPod. If the iPod
screen is blank, the iPod may have gone to sleep mode.
Press Menu on the iPod to turn it on.
Verify that the devices are within the recommended
range of approximately 30 feet (10 meters).
The headphone does not power on.
The battery charge may be too lo w. In this case, the
orange LED may flash and be accompanied by alert
beeps.
310
Product Features
Familiarize yourself with all of the controls located on the
right side of your iMuffs headphones. Please note that
the two LEDs are visible only when lit.
View of controls (right side)
Blue LED
Orange LED
Next/FF
button
Previous/Rewind
button
Power
switch
USB charging
port
Volume control/
button
Microphone
Play/Pause/
Phone button
For MB200 users, check that the volume on the iPod is
not all the way turned down.
The music or connection is not reliable
For optimal reception place your iPod with the connected
adapter on the right side of the headphones as this
where the receiving antenna is located in the headphones.
Overall relibility may be effected if used near microwave
applicances and/or certain radio emitting devices.