User manual

Unit 3: Interface Secifications
SATO MB2i Service Manual PN 9001145B Page 3-10
Figure 3-3a/b, SATO MB200i Properties
7. Check the COM1: Serial Port option to assign “SATO MB200i” to that port, then click on
Apply.
8. On the same screen, click on the Configure Port button.
9. When the COM1 Properties screen appears, click on each drop-down menu to change the
settings as follows: 19200 Bits Per Second, 8 Data Bits, no Parity, 1 Stop Bit, no Flow
Control. (Figure 3-4)
Figure 3-4, COM1 Properties
10. Click on the OK button to record the settings.
11. When the Properties screen appears, click on the OK button to record all settings.
12. When the main MB200i driver screen appears, click on its OK button.