User manual

Unit 7: Replacement Procedures
SATO MB2i Service Manual PN 9001145B Page 7-9
PANEL & LCD BOARD REPLACEMENT
1 Switch off the printer and remove power supply or battery.
2 Remove the front housing cover (Figure 7-7).
3 Remove the screw securing the panel board to the back side of the front housing cover.
4 Disconnect all relative wiring harnesses and discard the defective board.
5 Connect all relative wiring harnesses to the replacement panel board and secure using one
screw.
6 Install front housing cover to the printer chassis.
Figure 7-7, Panel & LCD Board Replacement
NOTE: Figure 9-1 of the Charts & Diagrams unit provides guidance on
housing cover removal.
NOTE: Figure 9-1 of the Charts & Diagrams unit provides guidance on
housing cover installation.
Panel BoardFront Cover
Screw x1