User manual

Unit 7: Replacement Procedures
SATO MB2i Service Manual PN 9001145B Page 7-15
DRIVE GEAR REPLACEMENT
1 Switch off the printer and remove power supply.
2 Remove the front and left housing covers.
3 Withdraw worn gears (A) and (B) from the printer chassis.
4 Insert replacement gears (B) and (A) into their respective positions identified by the
numeral 2.
5 Install all removed housing covers.
Figure 7-11, Gear Replacement
NOTE: Figure 9-1 of the Charts & Diagrams unit provides guidance on
housing cover removal.
NOTE: Figure 9-1 of the Charts & Diagrams unit provides guidance on
housing cover installation.
Gear (A)Gear (B) Printer Chassis