User Manual

Completing Pre-Installation
14 Version 1.1 - 01/04/00
6. Press the
Esc
key until you exit the Configuration menu.
7. Power down the computer.
You have completed the pre-configuration for the unit.
8. Repeat the steps in To configure a 300-24 unit as a base or remote station and To
assign the base station or remote station an RF Station ID for each unit you need to
pre-configure.
Pre-configuring the Polling List
1. Connect a computer to the 300-24 unit you configured as a base station via the RS-232
serial port.
Note:
The computer should be off when you connect it to the 300-24.
2. Power up the computer.
The Login menu appears.
3. At the Enter Password prompt, type your User Password.
Note:
When you start the 300-24 unit for the first time, the following user names and
passwords apply:
4. Press the
Enter
key.
The Main System menu appears:
User Name Password Access Level
user user Read-only access
supervisor supervisor Read/write access
You pre-configure
the polling list for
only the base
station.
Main System Menu
-> System Revision Information
System Software ROM Images
System Current Status
System Security
System Commands
Network Configuration
Radio Configuration
Remote Station Configuration
MAC Layer Statistics
Remote Station
Configuration only
appears in the Main
System menu for
units configured as
the base station.