User Manual
Table Of Contents
- Notices
- Welcome
- Get Started
- Completing Pre-Installation
- Determining the RF Link
- Installing Base and Remote Stations
- Configuring Using the Menus
- Using SNMP
- Appendix A: Product Specification
- Appendix B: Monitor and Test Links
- Appendix C: Upgrading Software
- Glossary
- Index
Configuring Using the Menus
60 Version 1.1 - 01/04/00
4. Press the
Enter
key.
The entry field changes to edit mode.
5. Scroll to select the IP Filter type you are configuring. You can select from:
6. Press the
Enter
key.
The IP Filter Type is defined.
7. Press the right arrow key on the keyboard to move to the Host/Net Address field.
8. Press the
Enter
key.
The entry field changes to edit mode.
9. Type the IP Address of the Host/Net.
10. Press the
Enter
key.
The address is defined.
11. Press the right arrow key on the keyboard to move to the Host/Net Mask field.
12. Press the
Enter
key.
The entry field changes to edit mode.
13. Type the IP Address of the Host/Net Mask.
14. Press the
Enter
key.
You have configured the IP filter.
15. Repeat steps 3 to 14 to define additional IP filters.
Select this filter... To...
ENET - Wireless (RF) Filter the packets received from the wireline.
Wireless (RF) - ENET Filter the packets received from the air.
Undefined Not filter the packets.