User's Manual
Table Of Contents
- Contents
- Important Information
- Notices
- Description
- Installation
- Configuration
- Overview
- Accessing the Main Menu
- Configuring with the Main Menu
- Unit Identification
- Hardware/Software Revision
- System Software ROM Images
- System Current Status
- Network Configuration
- IP Filter Configuration
- RF Station Configuration
- Viewing Current RF Station Configuration
- Setting the Operating Mode
- General Equipment Setup for Performing RF Tests
- Setting Test Mode Timer Minutes
- Performing Link Monitor Test (Normal Mode)
- Performing Transmit and Receive Tests
- Performing the RSSI Test
- Setting the RF Transmit Status
- Setting the Link Monitor Period
- Setting Maximum Remote Distance (Base Station Only)
- Setting Link Monitor Remote Station Rank
- Adjusting Throttling (Remote Station Only)
- Setting Tx Power Automatically (Remote Station Only)
- Adjusting User Output Power Ceiling (Remote Station Only)
- Setting Signal Margin (Remote Station Only)
- Viewing Current Output Power Level Adjust
- Radio Module Configuration
- Viewing the Radio Module Configuration
- Setting Config Test Minutes
- Setting the Station Type
- Setting the Station Rank
- Setting the Center Frequency
- Setting Security Passwords
- Setting the Scrambling Code
- Setting the Acquisition Code
- Adjusting the Tx Power Level
- Setting a Base to Repeater Mode (Base Station Only)
- Setting System Symmetry Type (Base Station Only)
- Setting Dynamic Polling Level (Base Station Only)
- Setting Remote Unit RF Group
- Rebooting and Saving RF Module Configurations
- RF/Ethernet Statistics
- System Security
- System Commands
- Link Monitor Display
- Logout
- Setting Operating Mode with the Mode Button
- Command Line Interface
- Troubleshooting
- Appendix A: Planning Your Wireless Link
- Appendix B: Using HyperTerminal
- Appendix C: Configuring a Simple Data Network
- Appendix D: SNMP
- Appendix E: Technical Reference Information
- Appendix F: Menu Map
- Appendix G: Upgrading Software
- Glossary
- Index
Configuration
90 AWE 120-24 Installation & Configuration Guide
2. Press Esc to exit to the Main Menu.
Ethernet Transmit
Total Packets
Transmitted
Number of Ethernet packets transmitted onto the
Ethernet connection
Packets From Local Host Number of Ethernet packets transmitted onto the
Ethernet connection which originated from the AWE
120-24 unit’s TCP/IP stack
Packets Dropped Number of Ethernet packets not transmitted due to
some error, for example, unable to transmit within 15
retries or underflow error
Total KBytes Transmitted Total number of kbytes transmitted from the Ethernet
port (broadcast and non-broadcast packets)
Broadcast KBytes
Transmitted
Number of kbytes transmitted from the Ethernet port
(broadcast packets only)
RF Transmit
Total Packets
Transmitted
Number of Ethernet packets transmitted over RF
Frames From Local Host Number of Ethernet packets transmitted to RF from
the local host
Packets Dropped Number of packets dropped because of RF problems
RF S. F. Tx
Super Frames Transmitted Number of super frames transmitted
Throughput
Ethernet-to-RF
Throughput
Current data rate measured from wire to air
Resolution = 1 second
RF-to-Ethernet
Throughput
Current data rate measured from air to wire
Resolution = 1 second