User's Manual
Table Of Contents
- Contents
- Important Information
- Notices
- Description
- Installation
- Configuration
- Overview
- Accessing the Main Menu
- Configuring with the Main Menu
- Unit Identification
- Hardware/Software Revision
- System Software ROM Images
- System Current Status
- Network Configuration
- IP Filter Configuration
- RF Station Configuration
- Viewing Current RF Station Configuration
- Setting the Operating Mode
- General Equipment Setup for Performing RF Tests
- Setting Test Mode Timer Minutes
- Performing Link Monitor Test (Normal Mode)
- Performing Transmit and Receive Tests
- Performing the RSSI Test
- Setting the RF Transmit Status
- Setting the Link Monitor Period
- Setting Maximum Remote Distance (Base Station Only)
- Setting Link Monitor Remote Station Rank
- Adjusting Throttling (Remote Station Only)
- Setting Tx Power Automatically (Remote Station Only)
- Adjusting User Output Power Ceiling (Remote Station Only)
- Setting Signal Margin (Remote Station Only)
- Viewing Current Output Power Level Adjust
- Radio Module Configuration
- Viewing the Radio Module Configuration
- Setting Config Test Minutes
- Setting the Station Type
- Setting the Station Rank
- Setting the Center Frequency
- Setting Security Passwords
- Setting the Scrambling Code
- Setting the Acquisition Code
- Adjusting the Tx Power Level
- Setting a Base to Repeater Mode (Base Station Only)
- Setting System Symmetry Type (Base Station Only)
- Setting Dynamic Polling Level (Base Station Only)
- Setting Remote Unit RF Group
- Rebooting and Saving RF Module Configurations
- RF/Ethernet Statistics
- System Security
- System Commands
- Link Monitor Display
- Logout
- Setting Operating Mode with the Mode Button
- Command Line Interface
- Troubleshooting
- Appendix A: Planning Your Wireless Link
- Appendix B: Using HyperTerminal
- Appendix C: Configuring a Simple Data Network
- Appendix D: SNMP
- Appendix E: Technical Reference Information
- Appendix F: Menu Map
- Appendix G: Upgrading Software
- Glossary
- Index
Antenna Basics
JUL 2001 Rev 03
123
The following list of minimum cable lengths required to comply with the EIRP limit set out in FCC part 15,
and RSS139 when using antennas of greater gain than 16 dBi, and up to the highest gain of 18.5 dBi (point to
multi-point application). These lengths result in at least 3.5 dB of loss at 2.4 GHz.
Tiltek Planar 1200-0315 20
Tiltek Sectoral 1200-0318 10
Tiltek Sectoral 1200-0325 12.5
Tiltek Sectoral 1200-0316 10–15
Tiltek Sectoral 1200-0317 16
Tiltek Sectoral 1200-0319 13–17.5
Tiltek Sectoral 1200-0324 18.5
Tiltek HSectoral 1200-0326 11.5
Tiltek HSectoral 1200-0327 14
Tiltek Shrouded Yagi 1200-0330 11.5
Conifer Directional 1200-0304 13
Conifer Directional 1200-0307 16
Conifer Directional 1200-0308 18
Conifer Directional 1200-0309 24
Cable Type Minimum Length (m)
LMR 400
16
LMR 600 25
LMR 900 37
LMR 1200
48
LMR 1700
63
LDF2-50 3/8"
19
LDF4-50A 1/2"
28
LDF5-50A 7/8"
48
LDF6-50 1 1/4"
66
RG58 A/U
3.5
Antenna Description Number Gain (dBi)