User's Manual
Table Of Contents
- Contents
- Important Information
- Notices
- Description
- Installation
- Configuration
- Overview
- Accessing the Main Menu
- Configuring with the Main Menu
- Unit Identification
- Hardware/Software Revision
- System Software ROM Images
- System Current Status
- Network Configuration
- IP Filter Configuration
- RF Station Configuration
- Viewing Current RF Station Configuration
- Setting the Operating Mode
- General Equipment Setup for Performing RF Tests
- Setting Test Mode Timer Minutes
- Performing Link Monitor Test (Normal Mode)
- Performing Transmit and Receive Tests
- Performing the RSSI Test
- Setting the RF Transmit Status
- Setting the Link Monitor Period
- Setting Maximum Remote Distance (Base Station Only)
- Setting Link Monitor Remote Station Rank
- Adjusting Throttling (Remote Station Only)
- Setting Tx Power Automatically (Remote Station Only)
- Adjusting User Output Power Ceiling (Remote Station Only)
- Setting Signal Margin (Remote Station Only)
- Viewing Current Output Power Level Adjust
- Radio Module Configuration
- Viewing the Radio Module Configuration
- Setting Config Test Minutes
- Setting the Station Type
- Setting the Station Rank
- Setting the Center Frequency
- Setting Security Passwords
- Setting the Scrambling Code
- Setting the Acquisition Code
- Adjusting the Tx Power Level
- Setting a Base to Repeater Mode (Base Station Only)
- Setting System Symmetry Type (Base Station Only)
- Setting Dynamic Polling Level (Base Station Only)
- Setting Remote Unit RF Group
- Rebooting and Saving RF Module Configurations
- RF/Ethernet Statistics
- System Security
- System Commands
- Link Monitor Display
- Logout
- Setting Operating Mode with the Mode Button
- Command Line Interface
- Troubleshooting
- Appendix A: Planning Your Wireless Link
- Appendix B: Using HyperTerminal
- Appendix C: Configuring a Simple Data Network
- Appendix D: SNMP
- Appendix E: Technical Reference Information
- Appendix F: Menu Map
- Appendix G: Upgrading Software
- Glossary
- Index
JUL 2001 Rev 03 167
Index
Numerics
10/100 BaseT connector 8
A
absorption
and antennas 121
defined 157
accessing
configuration menus 30–31
acquisition code 77
configuring 77, 78
defined 157
adding to your network 27
address
SNMP NMS trap IP address 41
adjusting Tx power level 78
adminstrative best practices 107
agent
defined 157
agents
SNMP 135
air vent
fan air vent 8
antennas 120–126
absorption 121
beamwidth 120
clearance requirements 125
connector 8
cross-polarization discrimination 121
dBd vs. dBi 120
defined 157
diffraction 121
downtilt 120
EIRP 124
fade margin 124
fine-tuning 126
front to back ratio 120
gain 115, 117, 120, 157
installation factors 124
list of approved 122
LOS 124
maximizing capabilities 124
minimal clearance 125
multipath interference 121
pre-installation 114
safety 124
selecting 122
shadowing 121
uptilt 120
voltage standing wave ratio 121
arrow keys
setting in telnet sessions 31
asymmetric
base station system type 81
attenuation
and antennas 117
defined 157
auto logout minutes 97
automatic logout timeout 97
automatic output power 63
automatic output power, explanation of 63
automatic Tx power adjust 63
B
back panel 8
LED 8
base station
defined 158
pre-configuration steps 15
repeater mode 80
setting 72
system symmetry type
asymmetric 81
symmetric 81
basic RF link 20
testing 22