User's Manual
Table Of Contents
- Contents
- Important Information
- Notices
- Description
- Installation
- Configuration
- Overview
- Accessing the Main Menu
- Configuring with the Main Menu
- Unit Identification
- Hardware/Software Revision
- System Software ROM Images
- System Current Status
- Network Configuration
- IP Filter Configuration
- RF Station Configuration
- Viewing Current RF Station Configuration
- Setting the Operating Mode
- General Equipment Setup for Performing RF Tests
- Setting Test Mode Timer Minutes
- Performing Link Monitor Test (Normal Mode)
- Performing Transmit and Receive Tests
- Performing the RSSI Test
- Setting the RF Transmit Status
- Setting the Link Monitor Period
- Setting Maximum Remote Distance (Base Station Only)
- Setting Link Monitor Remote Station Rank
- Adjusting Throttling (Remote Station Only)
- Setting Tx Power Automatically (Remote Station Only)
- Adjusting User Output Power Ceiling (Remote Station Only)
- Setting Signal Margin (Remote Station Only)
- Viewing Current Output Power Level Adjust
- Radio Module Configuration
- Viewing the Radio Module Configuration
- Setting Config Test Minutes
- Setting the Station Type
- Setting the Station Rank
- Setting the Center Frequency
- Setting Security Passwords
- Setting the Scrambling Code
- Setting the Acquisition Code
- Adjusting the Tx Power Level
- Setting a Base to Repeater Mode (Base Station Only)
- Setting System Symmetry Type (Base Station Only)
- Setting Dynamic Polling Level (Base Station Only)
- Setting Remote Unit RF Group
- Rebooting and Saving RF Module Configurations
- RF/Ethernet Statistics
- System Security
- System Commands
- Link Monitor Display
- Logout
- Setting Operating Mode with the Mode Button
- Command Line Interface
- Troubleshooting
- Appendix A: Planning Your Wireless Link
- Appendix B: Using HyperTerminal
- Appendix C: Configuring a Simple Data Network
- Appendix D: SNMP
- Appendix E: Technical Reference Information
- Appendix F: Menu Map
- Appendix G: Upgrading Software
- Glossary
- Index
AWE 120-24 Unit
JUL 2001 Rev 03
7
AWE 120-24 Unit
The AWE 120-24 has indicator LEDs on the front panel.
Front Panel
The front panel connector and LEDs are described below. The color of a LED indicates its status. See Front
Panel LEDs, page 149 for detailed information
Air LED Color of LED indicates the transmit/receive status of the wireless link:
Red = transmitting data to the air
Green = receiving data from the air
Orange = transmitting and receiving approximately equal amounts of
data over the air
Off = listening to the air
Mode LED Color of LED indicates the operating mode of a unit:
Green = Receive Test mode
Red = Transmit Test mode
Orange= RSSI Test mode (measures fade margin, which is indicated by
LED color)
Off = Normal mode
Wire LED Color of LED indicates the transmit/receive status of the wire link:
Green = receiving data from wire
Red = transmitting data to wire
Orange = transmitting and receiving data on the wire
Off = listening to wire or no wire connected
Power LED Green = power is connected to transceiver
Off = no power is connected to transceiver
Air
Mode Wire Power
Air Mode Wire Power