User's Manual
Table Of Contents
- Contents
- Important Information
- Notices
- Description
- Installation
- Configuration
- Overview
- Accessing the Main Menu
- Configuring with the Main Menu
- Unit Identification
- Hardware/Software Revision
- System Software ROM Images
- System Current Status
- Network Configuration
- IP Filter Configuration
- RF Station Configuration
- Viewing Current RF Station Configuration
- Setting the Operating Mode
- General Equipment Setup for Performing RF Tests
- Setting Test Mode Timer Minutes
- Performing Link Monitor Test (Normal Mode)
- Performing Transmit and Receive Tests
- Performing the RSSI Test
- Setting the RF Transmit Status
- Setting the Link Monitor Period
- Setting Maximum Remote Distance (Base Station Only)
- Setting Link Monitor Remote Station Rank
- Adjusting Throttling (Remote Station Only)
- Setting Tx Power Automatically (Remote Station Only)
- Adjusting User Output Power Ceiling (Remote Station Only)
- Setting Signal Margin (Remote Station Only)
- Viewing Current Output Power Level Adjust
- Radio Module Configuration
- Viewing the Radio Module Configuration
- Setting Config Test Minutes
- Setting the Station Type
- Setting the Station Rank
- Setting the Center Frequency
- Setting Security Passwords
- Setting the Scrambling Code
- Setting the Acquisition Code
- Adjusting the Tx Power Level
- Setting a Base to Repeater Mode (Base Station Only)
- Setting System Symmetry Type (Base Station Only)
- Setting Dynamic Polling Level (Base Station Only)
- Setting Remote Unit RF Group
- Rebooting and Saving RF Module Configurations
- RF/Ethernet Statistics
- System Security
- System Commands
- Link Monitor Display
- Logout
- Setting Operating Mode with the Mode Button
- Command Line Interface
- Troubleshooting
- Appendix A: Planning Your Wireless Link
- Appendix B: Using HyperTerminal
- Appendix C: Configuring a Simple Data Network
- Appendix D: SNMP
- Appendix E: Technical Reference Information
- Appendix F: Menu Map
- Appendix G: Upgrading Software
- Glossary
- Index
Configuration
32 AWE 120-24 Installation & Configuration Guide
Configuring with the Main Menu
This section describes how to configure units using the Main Menu. Menu items are discussed below in the
order that they appear in the menu.
Main Menu
Accessing Help
On-screen help is available for items listed in the Main Menu.
➧
To access help
1. From the Main Menu, select an item from the list and press Enter. The screen for the item is displayed.
2. Press
H on the keyboard. The Help Menu for the screen is displayed.
3. Place the cursor next to an item on the Help Menu and press
Enter. The help text for that item is
displayed.
Note: To navigate to the next page or to the previous page, press the up or down arrow keys on the
keyboard or follow instructions given at the top of the screen.
4. Press
Esc to exit to the Main Menu.
Wi-LAN AWE 120-24 Main Menu
-> Unit Identification
Hardware/Software Revision
System Software ROM Images
Current System Status
Network Configuration
IP Filter Configuration
RF Station Configuration
Radio Module Configuration
RF/Ethernet Statistics
System Security
System Commands
Link Monitor Display
Logout
How to Use the Main Menu
• To select an item from the Main
Menu or a sub-menu, press the
keyboard arrow keys to
move the cursor –
>
next to the
item.
Press the
Enter key to
open the data entry field.
• To scroll through items in the data
entry field, press .
Press to select an item
from the field.
• To exit from a menu, press the
Esc
key.
Enter
Enter
Esc