User's Manual
Table Of Contents
- Contents
- Important Information
- Notices
- Description
- Installation
- Configuration
- Overview
- Accessing the Main Menu
- Configuring with the Main Menu
- Unit Identification
- Hardware/Software Revision
- System Software ROM Images
- System Current Status
- Network Configuration
- IP Filter Configuration
- RF Station Configuration
- Viewing Current RF Station Configuration
- Setting the Operating Mode
- General Equipment Setup for Performing RF Tests
- Setting Test Mode Timer Minutes
- Performing Link Monitor Test (Normal Mode)
- Performing Transmit and Receive Tests
- Performing the RSSI Test
- Setting the RF Transmit Status
- Setting the Link Monitor Period
- Setting Maximum Remote Distance (Base Station Only)
- Setting Link Monitor Remote Station Rank
- Adjusting Throttling (Remote Station Only)
- Setting Tx Power Automatically (Remote Station Only)
- Adjusting User Output Power Ceiling (Remote Station Only)
- Setting Signal Margin (Remote Station Only)
- Viewing Current Output Power Level Adjust
- Radio Module Configuration
- Viewing the Radio Module Configuration
- Setting Config Test Minutes
- Setting the Station Type
- Setting the Station Rank
- Setting the Center Frequency
- Setting Security Passwords
- Setting the Scrambling Code
- Setting the Acquisition Code
- Adjusting the Tx Power Level
- Setting a Base to Repeater Mode (Base Station Only)
- Setting System Symmetry Type (Base Station Only)
- Setting Dynamic Polling Level (Base Station Only)
- Setting Remote Unit RF Group
- Rebooting and Saving RF Module Configurations
- RF/Ethernet Statistics
- System Security
- System Commands
- Link Monitor Display
- Logout
- Setting Operating Mode with the Mode Button
- Command Line Interface
- Troubleshooting
- Appendix A: Planning Your Wireless Link
- Appendix B: Using HyperTerminal
- Appendix C: Configuring a Simple Data Network
- Appendix D: SNMP
- Appendix E: Technical Reference Information
- Appendix F: Menu Map
- Appendix G: Upgrading Software
- Glossary
- Index
Configuration
46 AWE 120-24 Installation & Configuration Guide
Setting Up IP Address Filter
➧
To set up an IP address filter
1. From the IP Filter Configuration menu, select Range in the Filter Entry 1 row and press Enter.
The data field in the Range column highlights.
2. Type the Range (a number from 0–255) of the filter and press Enter to close the data field.
3. Press the down arrow key to select Base Address and press Enter. The data field highlights.
4. Type the IP base address and press Enter.
5. Press the down arrow key to select State and press Enter.
6. Scroll through the list and choose Pass, Block or Disable. Press Enter to save the setting.
7. To add another filter, press the down arrow key to go to the next filter entry number and fill in the data
fields.
8. Press Esc to save the filter settings and exit to the Main Menu.
IP Filter Configuration
IP Packet Filtering -> off
IP Address Filtering on
Default IP Address Filtering Pass
Filter Entry Range (0-255) Base Address State
------------------- ------------------- ------------------- -------------------
1 -> 100 0.0.0.0 Pass
2 0 0.0.0.0 Pass
3 0 0.0.0.0 Pass
4 0 0.0.0.0 Pass
5 0 0.0.0.0 Pass
6 0 0.0.0.0 Pass
7 0 0.0.0.0 Pass
8 0 0.0.0.0 Pass