Specifications

Wi-linktechCommunicationTechnologies(Shanghai)Co.,Ltd
Label and compliance information
Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the module
grantee on the required number of channels， modulation types， and modes，
it should notbe necessary for the host installer to re-test all the
available transmitter modes or settings. It is recommended that the host
product manufacturer， installing the modular transmitter， perform some
investigative measurements toconfirmthat the resulting composite system
does not exceed the spurious emissions limits or band edge limits (e.g.，
where a different antenna may be causing additional emissions).
b) The testing should check for emissions that may occur due to the
intermixing of emissions with the other transmitters， digital circuitry，
or due to physical properties of the host product (enclosure). This
investigation is especially important when integrating multiple modular
transmitters where the certification is based on testing each of them in
a stand-alone configuration. It is important to note that host product
manufacturers should not assume that because themodular transmitter is
certified that they do not have any responsibility for final product
compliance.
c) If the investigation indicates a compliance concern the host
product manufacturer is obligated to mitigate the issue. Host products
using a modular transmitter are subject to all the applicable individual
technical rules as well as to the general conditions of operation in
2019.09
www .w i - li nk te ch .c om
16
An exterior label on OEM’s end product can use wording such as the following:
“Contains Transmitter Module FCC ID: 2AOO6-WLT8016” or
“Contains FCC ID: 2AOO6-WLT8016”