User's Manual

Wi2Wi, Inc. Rev.1.1

Data Sheet, WLAN-Bluetooth Module– W2CBW009S

Dated: October 20, 2009

The content of this document is to be treated as strictly confidential and is not to be disclosed,

Reproduced or used, except as authorized in writing by Wi2Wi, Inc.

Page 18 of 20

9.1 Host Processor

The TCP/IP stack, Ethernet Driver and the 802.11 extensions reside on the host processor. The

Hardware Interface Driver, which can be G-SPI or SDIO, is partitioned between the host and the

firmware on the WiFi.

The WLAN firmware for the WiFi is downloaded through the selected host interface (G-SPI or

SDIO) by the Hardware Interface Driver at power up.

Once the firmware is downloaded, the Data Path and the Control Path between the host and WiFi are

established, and information can flow between the two devices.

10 Manufacturing Notes

10.1 Physical Dimensions and Pin Locations

•

Physical Size: 15mm x 15mm

•

Pad Size: 0.25mm X 0.63mm

•

Pad Spacing: 0.66 mm

•

Pins: 76 (4 x 19) +4 Corner ground Pads for shield

Figure 4: Physical Dimensions and Pin Locations for a Single Antenna Device