Installation Instructions

Outdoor Software Defined Radio (OSDR) platform
Installation & Cabling Manual - Edition 3.0
101
Outdoor DC PoNE, Continued
Pole and wall
installation
procedure
For mechanical installation and cabling of outdoor DC PonE, proceed as
follows:
Step Action
1
Pole installation:
A Attach the plate onto rear side of PonE, as shown below.
B:
Install lock washer and screw. Then use the cross headed screwdriver to fully
tighten.
C: Pass the hose clamp through the plate holes.
D: Install the PonE onto pole. Use the tool with M5 deep socket to tighten.
Do not over tighten. Adjust the tool for max tightening torque 2 Nm.
E:
Use the tool with TORX T10 bit to remove the six screws. Then detach the
PonE cover for installing the cables. Be careful not to drop the screws
while removing.
Wall Installation:
A: Perform step E as describes the above procedure.
B: Perform the following:
• Position the device on the wall surface and using a pencil mark the drill
points. With the drill machine (fitted with 5 mm bit), drill four holes on the
wall surface, at a depth of 45 mm.
• Install the four supplied wall plugs and using the cross headed screwdriver
and tighten the four screws.
Continued on next page