Installation Instructions

Appendix D: Cables Termination
124
AC Power Supply Cable, Continued
Procedure
To terminate the AC power supply cable to AC power connector of outdoor
AC PoNE, proceed as follows:
Step
Action
1 Perform the following actions:
A: Strip approx. 10 mm from the cable’s outer sheath.
B:
Strip approx. 4 mm from each wire insulation.
C: Pass the cable through the parts of gland.
D: Solder the 3 pins to the connector taking in consideration the following:
•
The
Yellow/Green
wire must be soldered to the pin shown below (white
arrow).
•
The remaining two black wires are for live
(L)
and neutral
(N).
Both wires
must be soldered to the other two pins.
There is no polarity concern
regarding these two specific wires.
Continued on next page