User Manual

5. Accessing a Radio Unit via Node Manager
28
5. Accessing a Radio Unit via Node Manager
Scope
This chapter provides the necessary instructions to log in to WiBAS radio
unit.
Default IP Address
Factory default
IP Addresses
The first time you access a radio unit , the default factory IP address (inband
or outband) is required:
•
Default
Inband
IP Address:
10.10.10.100/24
•
Default
Outband
IP Address:
192.168.1.100/24
Ethernet interfaces of laptop and inband management interface of
radio unit must belong to the same subnetwork.
To allow this, change temporarily the IP address of the laptop to the
same subnetwork that the inband management interface of radio unit
belongs to (for example, change laptop's IP address to 10.10.10.110).
Fail -safe IP
addresses
In case the communication with a radio unit cannot be established via
an outband connection, the use of the following fail-safe IP Address
may be required:
192.168.255.254
.
In case the communication with a radio unit cannot be established via
an inband connection, the use of the following fail-safe IP Address
may be required: 10.255.255.254.
See details
on Appendix B – Inband Management Connection
Troubleshooting on page 89.