User Manual

6. Equipment Commissioning
34
WiBAS-OSDR TS
Procedure
To configure the operational parameters of the WiBAS
TM
OSDR TS, please
follow the steps below:
Step
Task
See Reference Manuals item 3…
1 Management
Interfaces
(1)
How to change the outband / inband IP
address refer to Chapter 5 / Paragraph
“Configuring the Management Interfaces”.
2 Default Gateway IP
Address
How to configure the default gateway IP
address refer to Chapter 5 / Paragraph
“Configuring the Default Gateway IP
Address”.
3 Switching to TDMA-
60 Operation Mode
(2)
How to configure the operation mode
refer to Chapter 9 / Paragraph “Switching
to TDMA-60 Operation Mode”.
4
Modem
(Channel Bandwidth,
Modem profile)
How to configure the modem parameters
refer to Chapter 5 / Paragraph
“Configuring the Modem”.
5
Radio
(Tx Frequency, Tx
Power, Mute)
How to configure the radio parameters
refer to Chapter 5 / Paragraph
“Configuring the Radio”.
6
GbE Ports
(Speed, duplex &
negotiation mode).
How to configure the ports refer to
Chapter 5 / Paragraph “Configuring the
Ethernet Ports”.
7
Date / Time
How to configure the date and time refer
to Chapter 5 / Paragraph “Configuring the
Date / Time”.
8
Thresholds
(Temperature)
How to configure the temperature
thresholds refer to Chapter 5 / Paragraph
“Configuring Temperature Thresholds”.
Continued on next page
(1)
Also includes configuring of management VLAN.
(2)
This step applies only when WiBAS
TM
-Connect terminal stations must be connected to the sector.