User Manual

6. Equipment Commissioning
56
WiBAS-Connect TS , Continued
Procedure for WiBAS-Connect TS with Parabolic Integrated Antenna
To perform WiBAS-Connect TS parabolic integrated antenna alignment, please follow the
steps below:
Step Action
1 Perform coarse alignment, as follows:
Use the respective spanner key to rotate the assembly on the pole so that the
antenna is “visually” aligned with the target base station sector.
 Use compass and binoculars for alignment.
 Use the RF planning values for aligning the assembly to the target base
station sector.
Use the adjustable U-Wrench to apply the final tightening torque according
the ANTENNA INSTALLATION LEAFLET values.
2 Power on the terminal station.
Connect the RSSI cable as described to RSSI cable connection procedure on page
42.
Continued on next page