User Manual

WiBAS OSDR-Hub & Terminal Station / WiBAS-Connect Terminal Station
Start Up & Commissioning Manual - Edition 5.1
63
WiBAS-Connect TS , Continued
Procedure for WiBAS-Connect TS with Parabolic Low Profile Antenna, continued
Step Action
3 Perform coarse alignment, as follows:
Use the respective spanner key to rotate the assembly on the pole so that the
antenna is “visually” aligned with the target base station sector.
 Use compass and binoculars for alignment.
 Use the RF planning values for aligning the assembly to the target base
station sector.
 Use the adjustable U-Wrench to apply the final tightening torque (M8 u-
bolts nuts max tightening torque 15 Nm).
 U-Bolt fully tightening. Do not over tighten. Overtightening will cause
deformation of the support clamp.
Continued on next page