User Manual

WiBAS OSDR-Hub & Terminal Station / WiBAS-Connect Terminal Station

Start Up & Commissioning Manual - Edition 5.1

6.4. Checking Operation

Hub procedure

This paragraph describes how to check the WiBAS

-OSDR Hub operation

(taking in consideration that all commissioning works have been completed

successfully):

Step

Action

1 Communicate with WiBAS

OSDR-Hub through inband.

2 Go to Equipment Management > Radio and check the status as

shown below:

Go to

Equipment Management

> Modem

and check the status.

3 Go to Summary > Terminals and check the values of the

following:

• Connectivity: connected

• Physical Mode (UL & DL): “based on the radio planning data”

• RSSI: “based on the radio planning data”

• SNR: “based on the system expected data”

4 Go to

Alarm List

and check if active alarms exist (without

preventing system operation).

Go to Service Provisioning and check if the values of the following

are the expected ones:

• Bridge

• Ethernet CoS Flow

• Synchronization

(1)

End

of procedure.

Continued on next page

(1)

Synchronization is related to WiBAS-OSDR Hub only.