User's Guide

Development Kit User Guide – Rev11.0

After the update is complete, the “Current Firmware Version” and “Uploaded Firmware

Version” for the Onboard Charger should match. Note that it may take several seconds

for the web page to update after the status bar indicates “Update Complete”. During this

time, the Current Firmware Version may be shown as “Unavailable”.

If the system takes more than 5 minutes to update, restart both the Onboard Charger

and the Transmitter and try again.

If you are unable to finish the firmware update and your Onboard Charger appears to be

“stuck” in a non-functional mode, a recovery process is available. Use the area at the

bottom of the update page to enter the last six digits of the MAC Address for the OC

and press “Finish Update”. This will reset the OC and should allow completion of the

firmware update process. Contact WiBotic if you are unable to complete the update.