User Manual

28 29
The anchor can also be trimmed to fit your ear. There
are several ways of doing this. Two such examples
are shown here:
EXAMPLE 1
Pull the pointed end of the an-
chor through the upper hole
on the side of the tubing. The
angled grip should be pointing
towards the hearing aid.
Continue pulling until the an-
chor is stopped by the grip at
the end. Now turn the ear-set
around.
Guide the pointed end of the an-
chor through the lower hole to
form a loop.
When the loop is the correct size,
cut off any excess, leaving only the
loop.
EXAMPLE 2
Pull the pointed end of the an-
chor through the upper hole
on the side of the tubing. The
angled grip should be point-
ing towards the hearing aid.
Continue pulling until the an-
chor is stopped by the grip at
the end.
Loop the anchor in the direction in-
dicated by the dotted line and ar-
rows.
Guide the anchor through the lower
hole on the side of the tubing as il-
lustrated to form a loop.
When the loop is the correct size,
cut off any excess, leaving only the
loop.