User manual

CRU
UltraDock v4 User Manual A9-000-0026 REV 1.0 - 4 -
2.2 Hard Drive Attachment
2.2.1 IDE/PATA: 3.5-inch
If using a 3.5-inch IDE/PATA drive, configure the jumpers on your hard drive. The drive must be set to
the Master setting. Consult the instructions for your drive (some drives display configuration information
on the drive’s label). A few drives have both “Master with Slave Present” and “Master without Slave”
options. Choose the latter in this case. In rare cases, if the Master setting does not work then try Cable
Select.
Attach the free end of the IDE ribbon cable to the back of the hard drive. The
connector is keyed to insert only one way. The IDE pins on the hard drive
are fragile, so be very careful when inserting or removing the IDE connector
Attach the 4-pin power connector from the dock into the back of the hard
drive. As with the IDE cable, the power connector will only fit one way.
Attach the free end of the IDE ribbon cable to the back of the hard drive. The
connector is keyed to insert only one way. The IDE pins on the hard drive
are fragile, so be very careful when inserting or removing the IDE connector
Attach the 4-pin power connector from the dock into the back of the hard
drive. As with the IDE cable, the power connector will only fit one way.
2.2.2 SATA HDD: 3.5-inch & 2.5-inch
Take the SATA power/data cable and attach the 4-wire power input to the 4-wire power output from the
dock. Attach the SATA data cable to the SATA slot on UltraDock. Plug the SATA data/power connector
into the drive.
(Example)
IDE interface
Jumper
Pins
Power
Rear of hard drive