Manualshelf

User's Manual

ManualsBrandsWIESON INTERNATIONAL ManualsElectronicsWLAN/BT USB Module
567891011121314
WIESON
INTERNATIONAL
CO., LTD.
WM2012CU
User Manual
TYPE OF PRODUCT
WLAN/BT MODULE
CONFIDENTIAL
No part of the information shown of this document may be used in any way without office stamp or written consent of
WIESON INTERNATIONAL CO., LTD.
13
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed
such that 20cm may be maintained between the antenna and users. The final end product must
be labeled in a visible area with the following:
“Contains FCC ID: 2AAK6WM2012CU”
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module
in the user’s manual of the end product which integrates this module.The end user manual shall
include all required regulatory information/warming as shown in this manual.
IC Caution
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
z this device may not cause interference
z this device must accept any interference, including interference that may cause undesired
operation of the device
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence.L'exploitation est autorisée aux deux conditions suivantes:
z l'appareil ne doit pas produire de brouillage, et
z l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Pour se conformer aux exigences de conformité RF canadienne l'exposition, cet appareil et son
antenne ne doivent pas être co-localisés ou fonctionnant en conjonction avec une autre antenne
ou transmetteur.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed
such that 20cm may be maintained between the antenna and users. The final end product must
be labeled in a visible area with the following:
“Contains IC ID: 20126-WM2012CU”