User's Manual

ManualsBrandsWIESON Technologies ManualsAutomotiveTire Pressure Monitoring System

SC-T8 0 0 0 Se rie s TPMS

Fas t Installatio n Guide

Bluewave Technology Co., LTD.

Tel: 886-2-23451989 Fax: 886-2-23450177

2F.-1, No.5, Lane 178, Jhuangjing Rd.,

Sinyi District, Taipei Cit y 110, Taiwan, R.O.C.

htt p:/ / w ww.7brains.com/

Email: support@7brains.com

2007/ 4/ 18

Summary of content (5 pages)

PAGE 1
SC-T8 0 0 0 Se rie s TPMS Fast Installation Guide Bluew ave Technology Co., LTD. Tel: 886-2-23451989 Fax: 886-2-23450177 2F.-1, No.5, Lane 178, Jhuangjing Rd., Sinyi Dist rict , Taipei Cit y 110, Taiw an, R.O.C. ht t p:/ / www.7brains.com/ Email: support @7brains.
PAGE 2
─────────────────────────────── SC-T8000 Fast Installation Guide Welcome to Bluewave Super Cat T-Type 8000 Series Tire Pressure Monitoring System (SC-T8000 TPMS). This Fast installation Guide is intended to give you a fast overview of the key steps required to install your SC-T8000 Series TPMS. For more detailed information, please refer to the SC-T8000 Series TPMS User’s Manual.(http://www.7brains.com) Installation 1.
PAGE 3
─────────────────────────────── SC-T8000 Fast Installation Guide stationary. N ot e: ( 1) User m ay ignore t his fixt ure, when causing inflat ion hassle concerns. ( 2) To ensure LED t em plat e display cor r ect ly coincide w it h act ual sensor posit ion, Please follow st ep 4- Sensor alignm ent in order t o get right pressure and t em perat ure from right sensor. 4. Sensor alignment Plug the attached power cord into cigarette lighter directly, then activate the receiver. 4.
PAGE 4
─────────────────────────────── SC-T8000 Fast Installation Guide follow step 3 to install the next sensor installation, after finishing press Key4 (Exit). * a t t e n t ion : Finished inst alling, LED shows “ red “ , I f you set differ ent sensor I D in t he sam e place, t he LED will disappear, at t his m om ent you m ust r eset t he sensor. Example: Left-front tire didn’t receive data, shows “ t l ----”. 〔Signal〕 Right-front tire didn’t receive data, shows “ t2 ----”.
PAGE 5
FCC Notice: Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’ s authority to operate the device. This device complies with Part 15 of the FCC Rules.