User's Manual

Wifx L1 User manual revision 1.0

To press the button, use a thin tool such as a paper clip. Upon release, the status LED will briefly flash and then stop

to signal the reset action.

4.3.1 PROCEDURES

Short-press

Press briefly, for less than 1 second. The blue LED will briefly blink upon release

Long-press

Press and hold for several seconds. The blue LED will briefly blink after the delay specified below

Status LED

A short flash of the blue LED

Normal reset procedure

1. Short-press

2. The status LED will flash upon

release and the gateway will

reboot

Factory reset procedure

The factory reset procedure can be used to reset the initial default configuration and thus restore the device to

its original settings. This procedure is useful to solve a network misconfiguration or to recover a forgotten

password.

1. Wait at least 1 second after

another reset pressure.

2. Long-press for at least 10 seconds

3. After the LED starts blinking,

release the reset button.

4. The gateway will boot in factory

reset mode. When Linux has

started, a script will copy the

default files.

> 10sec

Programming mode procedure

This procedure is used to enter in programming mode. It enables the possibility to reprogram the gateway using

the Atmel SAM-BA programming tool through the USB port as summarized on the NAND Programming page of

the wiki.

1. Remove the microSD card from

the device

2. Wait at least 1 second for

another reset pressure

3. Perform 2 short presses with

less than 1 second between

each press

4. Perform a third long press for

more than 3 seconds (but less

than 5 seconds)

< 1sec < 1sec

> 3sec