User's Manual

Wifx L1 User manual revision 1.0
EN
30
10.3 MOUNTING ON WALL (INDOOR)
Using the accessory WHR-L01-W01, you can mount the Wifx L1 on a wall in indoor condition. The following
instructions describe how to proceed.
The WHR-L01-W01 is intended to be fixed on the Wifx L1 before
any installation on the wall.
The first step is to install the support on the back of the Wifx L1.
Use a torx T10 screwdriver to screw the two flat head screws at
the back of the Wifx L1.
Be careful to fix correctly the two screws ensuring the support
is not moving. Strength of screwing should be correctly adapted
to avoid on the contrary any pull-out of the metal inserts from
the plastic body.
The WHR-L01-W01 has space for the screw on one side,
make sure that the screws are in place when fully tightened
and that the head surface matches the support's surface as
shown in the picture.
The mounting of the bracket in the wall is done in two steps.
You first need to drill the first (upper) hole, put the plastic wall
plug and screw the first 4x30 wood doom head screw using torx
T20 screwdriver.
You must keep space for the support thickness. The support
must fit as showed below (without any product fixed on it for a
better illustration).