Instruction Manual

Operating Instructions Temperature Indicating Controller CS4S
V1.1
•
10/2006 - 12 -
5.1 Setup flow chart
MODE
PV/SV display mode
OUT
/
OFF
(approx. 1s)
Control output OFF function [
] or
Auto/Manual control function (*1)
Output manipulated
variable indication
MODE (approx. 3s)
MODE
+ MODE + MODE (approx. 3s)
[Main setting mode] [Sub setting mode] [Auxiliary function setting mode1]
SV 1
[
]
AT setting/Auto-reset
setting [ / ]
Setting value lock
selection [ ]
MODE MODE MODE
SV 2
[
]
OUT1 proportional
band setting [ ]
SV high limit setting
[ ]
MODE MODE MODE
OUT2 proportional
band setting [
]
SV low limit setting
[ ]
MODE MODE
Integral time setting
[
]
Sensor correction
setting [ ]
MODE MODE
Derivative time setting
[
]
Communication
protocol [ ]
MODE MODE
ARW setting
[
]
Instrument number
setting [ ]
MODE MODE
OUT1 proportional
cycle setting [
]
Data transfer rate
selection [ ]
MODE MODE
OUT2 proportional
cycle setting [
]
Heater burnout Alarm
setting [ . ]
Parity selection
[ ]
MODE MODE MODE
A1 setting
[
]
Loop break Alarm
action time [ ]
Stop bit selection
[ ]
MODE MODE MODE
A2 setting
[
]
Loop break alarm
action span [ ]
MODE MODE
•
+ MODE : Press the MODE key while the key is being pressed.
•
+ MODE (approx. 3s) : Press the MODE key for approx. 3s while the key is being pressed.
•
+ + MODE (approx. 3s) : Press the MODE key for approx. 3s while the and keys are being pressed.
• Dotted lines show options, which are indicated only when the options are applied.
(*1) If Auto/Manual control function is selected in the
OUT
/
OFF
key function selection, even though the
OUT
/
OFF
key is
pressed, control output OFF function does not work, but manual control is selected.