Use And Care Manual
12
Never use oil for 4-cycle engine or use water cooled 2-cycle engine. It can cause spark plug fouling exhaust
part blocking or piston ring sticking.
Mixed fuels, which have been left unused for a period of one month or more, may clog the carburetor or
result in the engine foiling to operate property. Put remained fuel into an airtight container and keep it in
the dark and cool room.
Fuel mixing table
Mixing procedure: 50 parts petrol to 1 part oil
Example:
1 l Petrol : 0,02 l 2-stroke oil
5 l Petrol : 0,1 l 2-stroke oil
Warning!
Take care of the emission of exhaust gases.
Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Take
care of fire!
Filling with fuel
Danger of injury! Fuel is explosive!
Turn the motor off and let the machine cool down.
Wear safety gloves.
Avoid contact with skin and eyes.
Make sure you observe the “Safety Instructions” para-graph.
Only ever refuel the tool outdoors or in sufficiently ventilated rooms.
Clean around the filling area. Contaminants in the tank will cause operating problems.
Before refuelling, shake the container with the fuel mixture.
Carefully open the fuel filler cap so that potential pressure can be release.
Carefully pour in the fuel mixture to the lower edge of the filler.
Close the fuel filler cap. Ensure the fuel filler cap closes tightly.
Clean the fuel filler cap and the area around it.
Check the tank and the fuel line for leaks.
Before starting the motor, remove yourself from the fuel-ling place by at least three meters.
Draining fuel.
Only ever empty the tank outdoors or in well-ventilated rooms.Make sure not to spill fuel or oil into the soil
(environmental protection). Use a proper base.
Hold a collection container beneath the fuel drain bolt.
Unscrew the tank cap and remove it.
Allow the fuel to run out completely.
Screw the tank cap on firmly by hand.
Check before use!
Check the safe condition of the device:
Check the device for leaks.
Check the device for visual defects.
Check that all parts of the device have been securely fitted.
Check that all safety devices are in proper condition.
Starting the blower
To start the Blower Ensure that the intermediate blower tube is fitted correctly
To use the appliance:
Follow the motor starting instructions as described in the operating instructions.
Let the motor run in idle mode and attach the appliance . Make sure that nothing is covering the
exhaust pipe as this would cause heat to build up.
Start
Once the machine has been set up properly, start the engine as follow:
1.Turn the engine switch(9) to the ON position .
2.
Put the choke lever (4) on the START
3.
Press the fuel pump(10) more than 5 times.