User's Manual

TO RECORD A MESSAGE
1. Maneuver Spy Bot into position and stop.
2. Press RECORD button to start recording (FIG 6). Recording time is 6 seconds. Spy Bot
will not operate while recording.
3. You may record over the previous message by pressing the RECORD button again.
4. When recording is finished, bring Spy Bot back to home base and press MESSAGE
PLAYBACK BUTTON to hear what Spy Bot heard.
WHEEL ALIGNMENT
1. When Spy Bot will not go in a straight line, adjust wheel alignment with the control
lever (FIG 7).
2. Move lever to the left if Spy Bot is turning right
3. Move lever to the right if Spy Bot is turning left.
FIG 7
Turn off Spy Bot and it transmitter after use to conserve batteries.
Don’t drive Spy Bot through puddles or mud, on a wet floor, or in sand, rain or snow. These
conditions can cause damage.
Don’t expose Spy Bot or it’s transmitter to temperature extremes.
Don’t store Spy Bot or it’s transmitter in direct sunlight or near a heat source.
Dead batteries can leak chemicals that cause damage. Never leave dead or weak batteries in
Spy Bot or it’s transmitter for long period of time.
FCC ID: N3ESPYROBOT70082T & N3ESPYROBOT70082R
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.