User's Manual

Power Save
Power On
Setting Time
Test Mode
After 30 seconds without any buttons
being pushed, the LCD will turn off and
camera enters into Power Save or
Ready Mode.
1.
1.
Check the battery level icon to ensure
the batteries just installed contain the
proper charge level. If so, you are ok to
proceed with camera use.
2.
PIR LED Status Light: During the first
2 minutes of Ready Mode, the red light
will illuminate when a PIR event is
triggered. The green light will blink
for 2-3 seconds when photo is taken
during this first 2 minutes. After 2
minutes all indicator lights will turn
off until a button is pressed.
1.
LCD Ready Mode: The camera will
automatically enter Ready Mode if a
button is not pressed for greater than
30 seconds. The status lights will
illuminate for a total of 2 minutes.
2.
The LCD screen can be awakened by
pressing the Power button briefly.
Note: The LCD will not “wake up” when
camera is writing to memory.
2.
To turn the unit ON press and release
the power button.
1.
To change date and time, start by
pressing and release the center
navigation button to set the hour.
2.
Press the left or right navigation
button to go up or down in sequence.
3.
When the hour is set, repeat steps 1
and 2 to set the minutes.
POWER
POWER
page 5
page 6
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
PIR Sense
Picture
Resolution
Delay
PIR Mode Flextime Both
P1 P2
Interval
Still Video
24Hr Day Night
Hi Med Lo
Regular Wide
Hi Med Lo
15s 30s 1m 2m 5m 10m
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
PIR Sense
Picture
Resolution
Delay
PIR Mode Flextime Both
P1 P2
Interval
Still Video
24Hr Day Night
Hi Med Lo
Regular Wide
Hi Med Lo
15s 30s 1m 2m 5m 10m
Open
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
PIR Sense
Picture
Resolution
Delay
PIR Mode Flextime Both
P1 P2
Interval
Still Video
24Hr Day Night
Hi Med Lo
Regular Wide
Hi Med Lo
15s 30s 1m 2m 5m 10m
Open
NOTE: LCD cycle through camera
information. PIR picture number >
Flextime number > Remaining
pictures > Time