Installation & Assembly

ASSEMBLY INSTRUCTION

E235C RIPPLE PATTERN ARC-SHAPED BACK OFFICE CHAIR WITH TILT

MECHANISM

Gas Lift

Pentagonal Feet

Caster

1pc

5pcs

Seat

Base Cap

Bracket With Handle

1pc

Bolt

Allen Wrench

M6 x 20mm

4pcs

1pc

This page lists all the contents included in the

box. Please take the time to identify the hardware

as well as the individual components to this

produ ct. As you unpack and prepare for

assembly, place the contents on a carpeted or

padded area to protect them from damage.

PAGE 1
ASSEMBLY INSTRUCTION E235C RIPPLE PATTERN ARC-SHAPED BACK OFFICE CHAIR WITH TILT MECHANISM A Gas Lift 1pc D Seat 1pc G Bolt B Pentagonal Feet C Caster 1pc 5pcs E Base Cap F 1pc Bracket With Handle 1pc H Allen Wrench M6 x 20mm M6 4pcs 1pc This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this p rodu ct.
PAGE 2
1 Attach Caster (C) to Pentagonal Feet (B) as shown. 2 Insert Gas Lift (A) and Base Cap (E) into assembled base carefully as shown.
PAGE 3
Attach Bracket With Handle (F) to Seat (D) by using Bolt (G) and Allen Wrench (H) as shown. 4 Attach Seat (D) to the chair base as shown. Cleaning & Care Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all connections are tight.