Assembly Instruction

NOTE: NO DRILLED HOLE OR PLASTIC ANCHOR
REQUIRED WHEN MOUNTING TO WOOD
WALL.USE SCREW ONLY. WE DO NOT SUPPLY
HARDWARE FOR MOUNTING ON CONCRETE
WALLS.
"the holes measurement on wall must match with the
holes measurement on back of the unit"
Find a desired location. Mark 2 locations for screws
on wall
One screw must be attached directly into a wall
stud. Wall anchor is not needed when mounting to
wall stud.
Drill one of the marking 1/4" hole.
Insert plastic anchors ( A ) into the holes of wall as
shown.
(When doing this, you will need a hammer help
you).
Using the Phillips head screwdriver, install screw
(B) into each of the anchors (A). Turn the screw (B)
in until there is a gap of 3mm between the head of
the screw and the wall as shown.
Install the unit onto the screw (B) and secure the
bracket is resting securely on the mounting screw
(B).
MIRRORED WALL SCULPTURE
Assembly Instructions