Assembly Instruction

EASY

The Assembly Rating is a 5-point system that

shows the degree of effort needed in

assembling a specific product (with 1 being

easy and 5 being difficult). For some

products, two persons are recommended.

Allen Wrench

(Included)

Assembly Instructions

Tools Required for Assembly:

Page 1 of 5

DIFFICULT

ASSEMBLY RATING

2 PERSONS RECOMMENDED

PAGE 1
Assembly Instructions ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
PAGE 2
Page 2 of 5
PAGE 3
Before you begin, please read Page 2 of “Assembly and Care Advice”. And remember, do not tighten until each step is completed or instructed.
PAGE 4
Align the threaded ends of the 4 levelers (#E) with the pre-drilled holes on the 2 leg stands (#1) and tighten by hand until secured. #E x 4 pcs Turn right (clockwise) to tighten Adjust the levelers according to the ground level on Step 4. #A x 4 pcs #C x 2 pcs #G x 2 pcs I. II. III. IV. Align the center stand support (#2) with the 2 leg stands (#1). Insert 2 Allen screws (#C) through the leg stands (#1) and secure those screws (#C) using the Allen wrench (#F) to lock them with the 2 leg stands (#1).
PAGE 5
Turn right (clockwise) to tighten #B x 4 pcs #D x 4 pcs I. II. III. Align the assembled leg stands (#1) with the predrilled holes on the table frame (#4). Prepare 4 bolt assemblies by inserting the flat washer (#D) onto the bolt (#B). Insert the bolt assemblies through the assembled leg stands (#1) and secure those bolts using the Allen wrench (#F) to lock them with the table frame (#4). I. Turn right (clockwise) to tighten #A x 6 pcs II. III. IV.