Wireless Earbuds T3 V4
Engli s h 01
Operating Manual 1. Product Overview earbuds indicator Charging contact Touch button Charging box indicator TYPE-C charging interface Charging contact Packing list: A. TWS Bluetooth earbuds 1 pair (1 charging case) B. earbud caps (large, medium, small) 1 set each C. Type-C charging cable 1 piece D.
2. Basic Features Button Function On Operation method User may turn on the earbuds after opening the charging case * When there is a pairing record, the earbuds will be re-connected to the device to which it is connected last time after being picked up from the charging case and turned on.
Wake-on -voice In standby or music mode, user may start voice assistant (either “touch button” on the left or right ear) by pressing and holding “touch button” for 2-3 seconds and releasing after hearing the “beep” sound. * Require mobile phone support. 3.Bluetooth Pairing and Connection A.
4. Indicator 4.1.
4.2. dump energy indicator of charging case Status When the residual power is 0% - 25% Indicator The first white indicator is on When the residual power is 25% - 50% The first and second white indicators are on When the residual power is 50% - 75% The first, second and third white indicators are on When the residual power is 75% - 100% The four white indicators are on 4.3.
6. Charging In case of T3 low-power alarm, please immediately put the earbuds into the charging case to charge. The charging time is 2 hours. When the earbuds is being charged, the indicator of charging case will display the current power of the charging case. When the earbuds is fully charged, the indicator of the charging case will go out.
turn it on. If re-connection failed or only one earbuds is working normally, you need to put the earbuds in the charging case, close its cover and keep for 5S, and then open the charging case for connection. B. How to clear the pairing record? After the earbuds is turned on, you may press the touch key for three times to clear the pairing history. After the pairing history is successfully cleared, the earbuds indicator will be on for 2S and then enter the left and right ear pairing state again.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
T3