Installation Instructions

ADA HANDRAILS

INSTALLATION INSTRUCTIONS

Railing Accents

™

90° WALL RETURN

1. Determine desired location of 90° Wall Return.

2. If required, cut Handrail pipe to proper length based

on location of wall return(s) or attachment to other

components.

3. Slide Joiner Ring onto Wall Return extension, followed by

Handrail pipe.

4. Prior to installing support bracket, insert post backer plate

into post, between screw chases, where Wall Return attach

screws will be applied. Ensure 90° Wall Return is parallel

to angle of railing system. See Detail A for placement of

backer plate.

TIP: Tape post backer plate to inside of post so that it does

not slide down inside post.

TIP: To help with angled attachment place one screw into

bottom hole of bracket and pivot wall mount to proper

position.

5. Attach 90° return to 3" post using 3x #10 x 1.50" colored

Tek Screws.

6. Slide return cover over 90° Wall Return before continuing

installation.

INSTALL ATION PROCEDURES

ADA SUPPORT BRACKET

1. Determine desired location of Support Bracket.

2. Prior to installing support bracket, insert post backer plate

into post, between screw chases, where Support Bracket

attach screws will be applied. Ensure Support Bracket is at

proper angle of alignment to angle of railing panels. See

Detail A for location of backer plate.

TIP: Tape post backer plate to inside of post so that it does

not slide down inside post.

TIP: To help with angled attachment place one screw into

bottom hole of bracket and pivot wall mount to proper

position.

3. Attach Support Bracket to 3" post using #14 x 1.50" Tek

Screw as shown.

Note: if attaching to a 2" post, be sure to use spacer as

shown in Detail B.

4. Install plug into Support Bracket.

5. Secure ADA Loop or Handrail to Support Bracket with 2x #8

x 3/4" colored Tek Screws from bottom of Support Bracket.

SUPPORT BRACKET

DETAIL B