Installation Instructions

ADA HANDRAILS

INSTALLATION INSTRUCTIONS

Railing Accents

™

RETURN LOOP WITH 90° RETURN

1. Cut ADA Loop ends as necessary to ensure that Support

Bracket will align properly with 3" post after installation.

NOTE: ENSURE 90° Return is at proper angle of alignment

to post. 90° Return is designed to have tight t into ADA

Handrail, thus location of attachment is critical.

2. Slide Joiner Ring over end of ADA Loop as shown.

3. Slide ADA Loop onto extension until Joiner Ring covers end

of 90° Return.

4. Secure ADA Loop to 90° Return by screwing 2x #8 x 3/4"

colored Tek Screws into bottom of ADA Loop.

5. Attach 90° Return to post per previous instructions.

INSTALL ATION PROCEDURES

RETURN LOOP WITH ADJUSTABLE ELBOW

1. If required, cut ADA Handrail pipe to proper length

based on location of wall return(s) or attachment to other

components.

2. Slide Adjustable Elbow into ADA Loop as shown.

NOTE: Reference Support Bracket installation section.

3. Secure Elbow to ADA Loop by screwing 2x #8 x 3/4" colored

Tek Screws into bottom of ADA Loop.

NOTE: Ensure Elbow is in line with ADA Handrail before

attaching.

4. Slide ADA Handrail into Elbow and secure by screwing 2x #8

x 3/4" colored Tek Screws into bottom of ADA Handrail.

5. Attach Support Bracket to post, then ADA Handrail to

Support Bracket per previous instructions.

ADA

LOOP

ADA

HANDRAIL

ADA

LOOP