Setup guide
DLR 60 2.0 Rechargeable Digital Receiver
Operating Instructions
DLR 60 2.0 compatible with Williams Sound DLT 100
and DLT 100 2.0 models only.
1. One DLT 100/2.0 assigned as the Master must be on.
2. Insert two AAA batteries into the DLR. Be sure
to observe correct polarity. If NiMH rechargeable
batteries are being used, change the battery type
switch from "ALK" to "NiMH". Failure to match
battery type with the switch may cause damage
to the unit.
3. Power on by holding the power button for 3 sec.
4. If the DLT 100/2.0 is in one-way/interpretation mode,
the DLR will seek an active DLT. Press the
^
or
v
button to seek the active DLT channel. In two-way
mode, group must be selected.
5. To change group, push the
^
or
v
button until the
correct group is displayed. It can take up to 5
seconds for the DLR to sync with the DLT.
6. The antenna symbol will ash if not synched with a
DLT 100/2.0. When synched, the antenna symbol
stays on and signal strength bars show up.
7. If the units are synched, briey push the power button
to show group assigned, 0 to 99.
8. To change volume level, press "vol+" or "vol-" button.
Display will show "VOLUME" and number "0"-"30".